top of page
RL series Reverse Osmosis Systems
18,000-300,000GPD / 3,000-50,000LPH
RL1.jpg
RL1.jpg

press to zoom
RL2.jpg
RL2.jpg

press to zoom
RL1.jpg
RL1.jpg

press to zoom
1/2

ROTEK RL series industrial reverse osmosis system is a durable piece of equipment that, with proper care and maintenance will last for many years. RL series RO systems are skid mounted with stainless steel frame, pre plumbed and pre-wired allowing for quick installation and start-up. Models are available with permeate outputs of between 3,000 and 50,000 litres/hr as shown in the specifications.

Standard Features

  • PLC control + mimic panel

  • Conductivity meter for permeate water

  • 300PSI FRP membrane housing

  • Grundfos multistage booster pump

  • 5 micron sediment pre-filter

  • Rotek rotameters for permeate and concentrate stream

  • Rotek pressure gauges for prefilter feed and RO feed

  • Danfoss low pressure switch

  • SS316 concentrate needle valve

  • Concentrate recycling with flow meter

  • Electro-plated SS304 skid frame

  • Provision for CIP and chemical dosing

  • Stainless steel pipeworks on high pressure side

  • UPVC SCH80 pipeworks on low pressure side

Benefits

  • PLC Control with Mimic Panel

  • Fully Equipped and Customizable

  • Factory Tested and Preserved

  • 1-Year Limited Warranty

  • Manufactured in Taiwan

Available Options

  • RO membranes are available with brands of
    Filmtec, Hydranautics, Vontron, and Toray

  • Higher pressure of multistage pump for feed TDS above 2,000 ppm or 5,000ppm

  • Digital sensors with remote monitoring

  • Raw water booster pump and controls

  • SS316 or Sanitary grade on pipes and vessels

Specifications

* Minimum recovery rate is calculated based on no concentrate recirculation,
  it is possible to increase the overall recovery rate by increasing the concentrate circulation flow.

** Permeate flow rate can vary depending on type of membrane, raw water quality, and recovery rate. 

bottom of page